Fire-lite ECC-50WBU Backup Amplifier Manuel d'utilisateur télécharger pdf

One Fire-Lite Place

Northford, CT 06472-1653 USA

203-484-7161 • FAX 203-484-7118

www.firelite.com

ECC-50WBU Backup Amplifier

Product Installation Document

PN LS10059-002FL-E:A 12/3/2013 14-121

The ECC-50WBU provides backup capability when operating the ECC-50BDA in the 100 watt with backup mode.

(Refer for the Distributed Audio Manual PN #LS10027-000FL00-E.)

The ECC-50WBU and ECC-50BDA are compatible with the ECC-50/100 Emergency Command Center (Manual PN

#LS10001-000FL00-E).

The ECC-50WBU mounts onto the ECC-50BDA board with the standoffs provided. Figure 1 shows the location of the

ECC-50WBU on the ECC-50BDA board.

To install the ECC-50WBU,

1. Make sure that all power supplied to the ECC-50BDA has been removed.

2. Insert the supplied M/F standoffs in the locations shown below.

3. Connect the backup amplifier cable harness (P/N 50116775-001) to the connector labeled “Backup Amplifier” on the

ECC-50BDA.

4. Lay the ECC-50WBU over the standoffs installed in step 2 and secure with supplied screws.

5. Connect the other end of the cable harness to the header on the ECC-50WBU.

6. Restore AC power and reconnect backup batteries.

Figure 1 Installing the ECC-50WBU

ECC-50WBU

screw and standoff

locations

connector

cable

eccdual50daBU.wmf

One Fire-Lite PlaceNorthford, CT 06472-1653 USA203-484-7161 • FAX 203-484-7118www.firelite.com ECC-50WBU Backup AmplifierProduct Installation Documen

Pas de commentaire

Fire-lite ECC-50WBU Backup Amplifier Manuel d'utilisateur