IPDACT-Configurator Application (V5.0) Quick User’s Guide IPDACT Dm 378-Iv3 1. Installation Requirements 1.1. PC • Pentium III processor or higher.
5. Installing the IPDACT using a Serial Port If you have the IPDACT connected to the Local Area Network where the IPDACT is going to operate and th
STEP 3 If the connection is successful, the “Quick Install” configuration screen appears. Contrariwise, an error message appears indicating the prob
If the LAN does not have a DHCP server you must fill in the next parameters: • Uncheck the Enable DHCP client box: This configures the device to use
Finally, select the ‘Register’ option. If the register operation has been successful, the following screen appears. Fig. 19 Where this is unsucce
6. IPDACT Local Parameters To access IPDACT local parameters, select the ‘Local Parameters’ option on the main screen (Fig. 2). Once the connection
7. Device status Device status lets you display a summary on the IPDACT status. The General Information tab shows the following information line by l
8. Disconnecting an IPDACT You can return to the main screen (see Fig. 2) from any of the configuration screens by using the ‘Back’ button. Discon
2. Executing IPDACT-Configurator The main screen (see Fig. 2) appears on executing the application. In this screen you can select among the options:
3. Installing the IPDACT using a crossover Ethernet cable If you have directly connected the IPDACT with the PC using a crossover Ethernet cable (
STEP 4 If the LAN (Local Area Network) where the IPDACT is going to be connected has a DHCP server you must fill in the next parameters in the “Quick
Dm378-Iv3 5 STEP 5 If the LAN does not have a DHCP server you must fill in the next parameters: • Uncheck the Enable DHCP client box: This config
4. Installing the IPDACT when it is connected to a hub or switch on the LAN When the IPDACT and the PC are connected to the Local Area Network where
If there is more than one device in the LAN you must locate the device through its Serial Number. The Serial Number appears on a sticker attached to
Dm378-Iv3 8 STEP 5 Fill in the next parameters in the “Quick Install” screen (see Fig. 5): • Check the Enable DHCP client box: This configures t
STEP 10 Once the IPDACT has the parameters, you need to register the IPDACT in the central. The next screen to appear after clicking on ‘Configure’
Commentaires sur ces manuels